For You R Safety - Ope Rati Ng You R Barbecu E - Char-Broil 19609080 Guide Du Produit

FOR YOU R SAFETY - OPE RATI NG YOU R BARBECU E

Ignitor Lighting
READ INSTRUCTIONS BEFORE LIGHTING. Do NOT lean over barbecue
while lighting.
1. Turn gas burner control valve to
2. Turn ON gas cylinder.
3. Open the barbecue lid.
4. Press and turn the control knob to the Ignition
5. Push and hold ELECTRONIC IGNITOR button until the burner lights.
6. Once the burner has ignited, turn the control knob to the desired setting.
7. If ignition does not occur in 5 seconds, turn the burner control knob
and repeat lighting procedure.
W A R N I N G
Turn controls OFF and disconnect LP cylinder when not in use.
Match Lighting
Do NOT lean over barbecue while lighting.
1. Turn gas burner control valve to
2. Turn ON gas at cylinder.
3. Open barbecue lid.
4. Strike match. Insert match into match lighting hole. Place lit match near the burner.
5. Press and turn the control knob to the Ignition
Match Light Hole
Burner Flame Check
Light burner. Make sure burner stays lit while rotating the burner control knob from
. Always check flame prior to each use.
.
position.
, wait 5 minutes,
.
position.
HIGH
LOW
Before Cooking For The First Time
• Leak test your barbecue. Operate barbecue for 15 minutes
with the barbecue controls on
internal components and eliminate odor from paint finish of
barbecue.
Turning Barbecue Off
• After cooking, turn the barbecue off by rotating the control
knob to
position. If control knob does not pop up, disconnect cylinder
to turn barbecue off and replace the Valve assembly.
• Allow barbecue to cool completely before storing.
S t o r i n g Yo u r B a r b e c u e
• Allow barbecue to cool completely.
• Remove LP Cylinder and install protective cap over outlet
threads.
I f B a r b e c u e F a i l s To L i g h t
• Make sure gas is turned on at cylinder. Make sure there is gas
in the cylinder.
• Does the ignitor make a sparking noise?
• If yes check for spark at burner.
• If no spark - check for damaged or loose wires.
• If wires are OK check for cracked or broken
electrode, replace if needed.
• If wire or electrodes are covered by cooking
residue, clean electrode tip with alcohol wipe
if needed. If needed replace wires.
• If no sound check battery.
• Make sure battery is installed correctly.
• Check for loose wire connection at module and switch.
• If ignitor continues to not work then use match.
to
Pa ge 9
. This will heat-clean
OFF. Control knob should pop up in the
C H A R B R O I L. E U
OFF