Flex LW 1202 N Notice D'instruction D'origine page 19

LW 1202 N/~SN / LW 1503/~S / LW 802 VR/~S
Connecting the water
WARNING!
Keep water away from the electric power
tool and from people within the operating
range. Do not switch on power tools which
have not been connected correctly to the
water supply. Regularly check that seals,
shut-off valve and connectors function
correctly.
Ó Attach ½" water hose to standard self-
locking quick coupling.
Ó Do not open shut-off valve until at the
place of use and the grinding tool is
rotating.
Ó When removing the hose, ensure that
no water runs into the machine.
Attaching or changing the grinding
tool
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
 Pull out the mains plug.
 Place machine on its back.
NOTE
The M14 thread must have a depth of at
least 20 mm.
 Hold the spindle with the enclosed
wrench (1.).
 Screw tool holder (Velcro or support pad)
onto the spindle (2.).
 Attach grinding tool to tool holder.
Function test:
 Insert the mains plug into the socket.
 Switch on the grinder (without locking
the button) and leave it running
for approx. 30 seconds.
Check for imbalances and vibrations.
 Switch off the grinder.
Switch on and off LW 1503/~S
Brief operation without engaged switch
rocker
 Push the switch rocker forwards and hold
in position.
 To switch off the power tool, release
the switch rocker.
Continuous operation with engaged
switch rocker
CAUTION!
Following a power failure, the switched-on
machine will start running again.
 Push the switch rocker forwards and
engage by pressing the front end.
 To switch off the power tool, release the
switch rocker by pressing the rear end.
19