DeWalt D21580 Traduction De La Notice D'instructions Originale page 35

WARNING: The declared vibration
emission level represents the main
applications of the tool. However if the
tool is used for different applications,
with different accessories or poorly
maintained, the vibration emission may
differ. This may significantly increase the
exposure level over the total working
period.
An estimation of the level of exposure to
vibration should also take into account
the times when the tool is switched off
or when it is running but not actually
doing the job. This may significantly
reduce the exposure level over the total
working period.
WARNING: Identify additional safety
measures to protect the operator from
the effects of vibration such as: maintain
the tool and the accessories, keep
the hands warm, organisation of work
patterns.
Fuses:
Europe 230 V tools
U.K. & Ireland 230 V tools
NOTE: This device is intended for the connection to
a power supply system with maximum permissible
system impedance Zmax of 0.25Ω at the interface
point (power service box) of user's supply.
The user has to ensure that this device is connected
only to a power system which fulfills the requirement
above. If necessary, the user can ask the public
power supply company for the system impedance
at the interface point.
Defi nitions: Safety Guidelines
The definitions below describe the level of severity
for each signal word. Please read the manual and
pay attention to these symbols.
DANGER: Indicates an imminently
hazardous situation which, if not avoided,
will result in death or serious injury.
WARNING: Indicates a potentially
hazardous situation which, if not
avoided, could result in death or
serious injury.
CAUTION: Indicates a potentially
hazardous situation which, if not
avoided, may result in minor or
moderate injury.
NOTICE: Indicates a practice not
related to personal injury which, if
not avoided, may result in property
damage.
EC-Declaration of Conformity
MACHINERY DIRECTIVE
D21580, D21582
D WALT declares that these products described
E
under "technical data" are in compliance with:
2006/42/EC, EN 60745-1, EN 60745-2-1;
(Stationary use:) EN61029-1, EN 61029-2-6.
These products also comply with Directive
2004/108/EC. For more information, please contact
D WALT at the following address or refer to the
E
back of the manual.
The undersigned is responsible for compilation of the
technical file and makes this declaration on behalf of
D WALT.
E
10 Amperes, mains
13 Amperes, in plugs
Horst Grossmann
Vice President Engineering and Product
Development
D WALT, Richard-Klinger-Straße 11,
E
D-65510, Idstein, Germany
01.01.2010
General Power Tool Safety Warnings
SAVE ALL WARNINGS AND INSTRUCTIONS
The term "power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
1) WORK AREA SAFETY
a)
b)
Denotes risk of electric shock.
Denotes risk of fire.
WARNING! Read all safety warnings
and instructions Failure to follow the
warnings and instructions may result in
electric shock, fire and/or serious injury.
FOR FUTURE REFERENCE
Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power
tools create sparks which may ignite the dust
or fumes.
EN GLIS H
33