Fisher & Paykel RF170 Instructions D'installation Et Guide D'utilisation page 25

To reset the filter indicator
Important!
We recommend the water filter is used from the point of installation.
Do not reset indicator before filter is changed or filter monitoring will be inaccurate.
Press and hold and
■ ■
If the filter is present the
■ ■
To disable the filter indicator
Note: if disabled, you will not be reminded to change your filter.
When no filter is to be fitted, you can disable the filter indicator.
■ ■
Press and hold
■ ■
When activated or deactivated the
■ ■
We recommend that you do not disable the filter indicator if you have a filter fitted to
■ ■
the connection.
Important!
To avoid serious illness or death, do not use the water filter where water is unsafe or of unknown
■ ■
quality without adequate disinfection before or after use of filter.
The water filter cartridge needs to be changed when the filter indicator icon flashes on the
■ ■
interface panel.
We recommend the water filter cartridge is replaced when the
■ ■
every 6 months.
If the water filtration system has been allowed to freeze, replace filter cartridge.
■ ■
The rate of water flow through the water dispenser can slow down as the filter cartridge
■ ■
accumulates any sediment which may be present in the water supplied to your home. This varies
depending upon your local water quality, which may require your filter cartridge to be changed
more frequently.
In cases of excessively reduced filter life we recommend that you consult a local plumber or your
■ ■
water supplier for advice on suitable filtration requirements for the water supplied to your home.
Filter replacement is the consumer's responsibility and will not be covered by the warranty
■ ■
except in the case of faulty parts or materials within the filter cartridge.
If the water has not been dispensed for some time or water has an unpleasant taste or odor,
■ ■
flush system by dispensing 10qt (10 L) of water.
If unpleasant taste or odor persists, you may wish to fit a new filter cartridge.
■ ■
buttons for 4 seconds to reset the filter indicator.
icon in the
, and buttons for 4 seconds to turn this feature off/on.
icon will flash and on or off will be displayed on the
screen.
Water filter
screen will disappear when reset.
icon flashes. This will happen
US
23
CA