Setting Timer; Sound Quality; Bluetooth Operation - LENCO DAR-070 Guide D'utilisation

Table des Matières

Les langues disponibles

You can use the setting timer to make the unit automatically turn on and off at a certain time every

day from standby.

The clock must be correctly set for the timer to operate correctly.

Set the unit to Standby mode;

Press the TIMER button to the on/off timer function;

Press and hold the TIMER button for timer setting. Select source by

fortimer on by digital keys on RC, then, set volume by

offby digital keys on RC. Note, for all steps, you need to press the TIMER button to confirm

and goto the next step. If there is no operation in 10 seconds, it will be exit automatically.

If the selected source is BUZZER, then, the TIMER OFF setting is not available.

Adjusting the Volume

To increase or decrease the volume, rotate the VOL+/- button on the unit or press the

VOL+/-buttons on the remote control.

If you want to turn off the sound, press the button on the remote control. Press the

buttonagain or press the VOL+/- button to resume normal listening.

Note, if you adjust the volume above 26, then power off and power on again, the volume will

restore to the factory setting automatically.

Adjusting the Bass

Press the USER button on the remote control, then press the BASS +/- buttons on the remote

control to increase/decrease the bass.

Adjusting the Treble

Press the USER button on the remote control, then press the TREBLE +/- buttons on the

remotecontrol to increase/decrease the treble.

Preset Equalizer

You can select sound characteristics such as CLASS/POP/ROCK/JAZZ/NORMAL by pressing the

EQ button.

You can listen to tracks from a media device if it is connected to the unit via Bluetooth.

Pair Bluetooth-enabled Devices.

You need to pair your Bluetooth device with this unit before you connect them for the frst time.

In order to avoid interferences, de-activate Wi-Fi on your device(Smartphone, tablet, etc...)

when playing music using Bluetooth.

Setting Timer

, then input time

, after that, input the time for timer

Table des Matières