JENCONS Powerpette Pro Notice D'emploi page 6

Recharging the Powerpette
Before starting to operate, carefully check mains voltage and recharge batteries.
To charge the Powerpette
1 Recharging temperature +10°C to +35°C.
2 Plug the charger jack (6) into the base of the Powerpette
3 Plug the charger (5) into a suitable wall socket. The red indicator on the charger will light up.
4 Place Powerpette onto bench stand.
®
5 Allow unit to charge for 14 hours from empty to fully charged.
6 Once the Powerpette
tion and the red indicator will turn off. If the charge to the Powerpette
started, the charger starts its full 14 hour charging cycle again.
This will not damage the battery.
Only use the charger indoors and protect against moisture.
Fitting the Powerpette
The Powerpette Pro bench stand is supplied ready to use as a wall bracket. When used as a bench
®
stand it is recommended that the wall fitting is
removed.
Bench stand
® Pro / Powerpette
Pro / Powerpette Quicksilver
® ®
is fully charged, the charger automatically switches to a trickle charge opera-
®
® Pro / Powerpette
Pro & Quicksilver Operator Instructions
® Quicksilver
.
®
® Quicksilver wall bracket
Wall bracket
is interrupted and then re-
®
5