Publicité
Les langues disponibles
Les langues disponibles
PARTS AND MAINTENANCE INFORMATION
CAUTION
The use of other than genuine ACDelco Tools replacement parts may result in
safety hazards, decreased tool performance and increased maintenance, and
may invalidate all warranties.
Repairs should be made only by authorized trained personnel. Consult your
nearest ACDelco Tools Authorized Service Center.
When the life of the tool (these tools) has expired, it is recommended that the
tool (these tools) be disassembled, degreased and parts be separated by material
so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized
Service Center.
Refer all communications to the nearest ACDelco Tools Distributor.
Proper lubrication of this air tool (these tools) is critical to the operation and life of the
unit. Units can be severely damaged or have excessive wear placed on working parts if
not lubricated.
Before connecting the air hose, it should apply 4 to 5 drops of #60 spindle oil at air
inlet. The repeated oiling after 3 to 4 hours operation will be necessary.
WARNING
objects.
Disconnect the tool (these tools) at its air inlet from the air supply system
NOTE
before any lubrication. Connect the tool (these tools) to an air supply
system and cover the exhaust with a towel and run for a few seconds after lubrication
is finished. Be careful to keep the towel away from moving parts.
Put the tool in dry and clean environment. If the tool shall not to be used for a period of
time, the residual moisture inside of the instrument could cause the rust. Before storage,
oil the instrument at air inlet with spindle oil and operate it for a short period is strongly
recommended.
1English1
MAINTENANCE & REPAIRS
LUBRICATION
Any excess oil in the motor is immediately expelled from the
exhaust port. Always direct exhaust port away from people or
STORAGE
English
-10
Publicité
