ACDelco AND301 Manuel Informations Du Produit page 10

Air Pressure:
Always use the clean and dry air to operate the tool at 90 psi (6.2 bar) & do not
operate exceed maximum working air pressure at 90 psi (6.2 bar) as recommended.
Air Line
Use a fitting air house for connection between the compressor & tools.
The compressed air is cooled and its water content would be sorted when the air
blow out the compressor.
Part of the water could be compressed in the pipe and could permeate into the
tool's mechanism to cause mechanical failures.
It would be strongly recommended to install an air filter, moisture separator,
regulator and lubricator among the air supply and the air tools.
Air Hose
Before connecting the hose to air tools, please clean firstly the hoses with a
blowout of compressed air.
This will prevent both moisture and dust contented within the hoses form entering
the tools and causing the possible rust and malfunction.
Always use clean, dry air as excessive moisture will lower the available
NOTE
torque and rust the interior moving parts. Make sure all hoses and fittings
are of the recommended size and be sure the tool is not used with more than or less
than the recommended pressure at the tool!
1English1
RECOMMENDED AIR SUPPLY SYSTEM
English -9