Rear View - Wacom DTF-521 Guide D'installation Et Manuel D'utilisation

REAR VIEW

Pen storage compartment
For storage, insert one end of the pen into either side of the storage compartment.
Then gently press the other end of the pen into the compartment.
For removal, press in on either end of the pen. This will pop the opposite end of the
pen out of the compartment. You can then remove the pen.
Kensington security slot
Allows easy attachment of
a security cable.
Pen tether attachment points
If you will be using the pen tether,
use the tether attachment ring and
small thumb screw to connect it to
one of four attachment points
located on the back of the unit.
Important: Always store the pen display on a stable surface or in its original packing carton when not
in use. Be sure to adjust the stand to the low tilt position before packaging the DTF-521. If you do not
close the stand, the notched mechanism may be damaged during transportation and storage.
Do not lift the unit by the stand; this may damage the stand mechanism. When lifting or moving the
DTF-521, always do so by grasping the main body casing.
C Be careful to avoid catching your finger in
AUTION
the gap of the movable portion of the stand.
Stand adjustment lever
Pull this lever up to adjust
the stand. Release the
lever to lock the stand in
place.
Video, USB, and
power connectors
Stand
The stand can be used
to adjust the tilt angle of
the unit.
Your new DTF-521
Page 9