Fisher & Paykel DCS CPU/CPV-484GG Guide D'utilisation page 23

Problem
Cooktop burners
There is a power failure –
can I still use the cooktop
burners?
The flames have
suddenly gone out.
There is a slight
'extinction pop' or
flash after I've turned a
cooktop burner off.
Possible causes
Power outage in your area.
A draft or a spill has extinguished
the flame.
Troubleshooting
What to do
The cooktop burners can still be
used. To light them:
Holding a lighted match to
1
the flame spreader, push
in on the control knob and
turn counterclockwise to
LITE.
When the flame is burning
2
all the way around the
burner, you may adjust the
heat.
Important!
If the flame is blown out during
a power failure, turn the knob
immediately to OFF , as the
burner will not automatically
relight and gas may escape.
No action required. The
burner will detect this and
automatically relight. However,
if there has been a large spill,
we recommend turning the
burners off and cleaning the
burners and sump area. See
'Care and cleaning' for
instrucions.
This is normal for LP gas and
requires no action.
21
US
CA