Caring For Your Aquasmart™ Washer - Fisher & Paykel AquaSmart Instructions D'installation Et Guide De L'utilisateur

Caring for your AquaSmart™ washer
36
When you have finished the cycle
Turn off the faucets to prevent the chance of flooding should
a hose burst.
Unplug the washer from the wall socket.
Cleaning your AquaSmart™
Before you start cleaning your AquaSmart™ washer, ensure
that it is turned off at the wall, or that the Key Lock mode has
been activated (refer to page 34).
Cleaning the Soft Touch Buttons, Screen and Topdeck
Use a soft damp cloth to wipe all surfaces, and wipe dry. Avoid
using chemical or scouring cleaners, as these will damage the
paint and plastic surfaces of your washer.
Cleaning the Lid
You can also remove the lid for cleaning. Open the lid fully,
grasp the lid on both sides. Lift in an upward motion, as shown.
To replace the lid, hold the lid vertically and align both hinges
before pushing downwards and slotting back into place.
Cleaning the Detergent, Fabric Softener and Bleach
dispenser
Wipe out the detergent dispenser with a damp cloth.
The funnels of both the fabric softener dispenser and the
bleach dispenser (the top) click off easily. Simply place a finger
down the center and lift. The dispenser receptacle is not
removable and needs to wiped clean periodically. If the siphon
tube looks partially blocked use a cotton bud to clean.
Important!
Ensure that the fabric softener and bleach dispenser funnels are replaced after cleaning, before
you start your next wash.
Fig.17 Removing the lid
Fig.18 Removing the
Fabric Softener dispenser
funnel