Trouble Shooting - Schneider MW 720 Mode D'emploi

2. Clean the outside with a damp cloth. Water should not run into the ventilation-
openings to prevent damage to the operating parts inside the appliance.
3. Wipe both sides of the door and the window, the door seals and adjacent parts
frequently using a damp cloth to remove any spills or spatters. Do not use
abrasive cleaners.
4. The control panel should not become wet. Clean it with a soft and damp cloth.
When cleaning the control panel, leave the door open so the appliance cannot
be switched on accidentally.
5. If steam accumulates inside or around the outside of the door, wipe it with a
soft cloth. This may occur when the appliance runs under high-humidity-
conditions. It is a normal occurrence.
6. It is sometimes necessary to remove the turntable and/or rotating ring for
cleaning. Wash the turntable/ring in warm soapy water, then rinse and dry
thoroughly. When having removed the rotating ring from the appliance, you
must reinstall it in its proper position.
WARNING! If it is necessary to remove the internal light
appliance, please contact the shop you purchased the appliance at.

6. Trouble shooting

Interference to radio or
television reception
Dim oven light
Steam accumulation on
door/hot air escapes from the
air vents
The appliance was accidentally-
started without load (food).
2
Equipment depending on model.
N
ORMAL OPERATING CONDITIONS
Radio and TV reception can be interfered while
the appliance
interferences of other electric appliances such as
mixers, vacuum cleaners, electric fans etc.
The oven light may become dim while the
appliance is operating in lower power cooking.
During cooking, steam escapes from the food.
Most of the steam is discharged via the
ventilation openings. Nethertheless, some steam
can accumulate at the cooler parts of the
appliance, e.g. the door.
WARNING!
appliance when it is empty.
is operating, similar
Never operate
2
of the
to
the
42