Fisher & Paykel ActiveSmart RF170 Guide D'utilisation page 12

Installation instructions
US
10
CA
Before placing food in the fresh food or freezer compartments
Remove all packaging. Ensure that all transit clips are removed from the refrigerator. These are
■ ■
small rubber stops located at the back of the shelves.
Allow the refrigerator and freezer to run empty for 2 – 3 hours to allow each compartment to
■ ■
cool to the appropriate temperature.
Clean the inside of the appliance with warm water and a little liquid detergent to remove
■ ■
manufacturing and transportation dust.
The appliance may have an odor on its initial operation, but this will go when the refrigerator
■ ■
and freezer have cooled sufficiently.
Energy efficiency
For the most energy efficient use of your appliance:
Ensure your refrigerator has adequate ventilation as recommended in the installation
■ ■
instructions.
Do not cover your appliances with any material that will prevent air from flowing around the
■ ■
cabinet sides.
Allow good clearances in front of the air ducts within the cabinet for maximum cold
■ ■
air distribution.
Cool hot foods down before placing them in the appliance.
■ ■
Do not overfill the compartments.
■ ■
Keep door openings to a minimum.
■ ■
Select a temperature setting that isn't too cold.
■ ■
Check your door seals for leaks.
■ ■