Avintage AVU8X Notice D'utilisation page 58

The winter system (depending on the model)
The winter kit is a frost protection system which enables the cellar to operate in an environment where the
temperature is between 0 and 32°C. A sensor located inside the appliance triggers a low power electrical
element when the inner temperature of the wine cellar becomes inferior by 3°C than the set temperature.
This is a low power element to avoid sudden rises in the temperature of the wine and so avoid thermal
shocks that are damaging to the preservation of the wine. The kit is intended to raise the cellar's internal
temperature even before there is a thermal exchange with the bottles.
The kit is designed to heat the internal temperature of the cellar even before a heat exchange has
occurred with the bottles. The winter system keeps the temperature inside the wine cellar the same as the
programmed temperature. When the system is activated and the internal temperature reaches the set
temperature, the system stops.
Shelves

To prevent damage to the door seal, ensure that the door is fully open before pulling out the shelves
to add or remove bottles.

For easier access to the contents of the shelves, slide the shelf out approximately one third of the
way. The shelves are, however, fitted with a stop to prevent the bottles falling out.

To remove or reposition the shelves, incline the shelf as indicated in the diagram, then push or pull as
required.
For AVU41SXDPA(/IX)
Place the shelves in the spaces provided.
a. Spare part cardboard box
1. After removing the wrapping, take the spare parts cardboard box (a) out of the cabinet.
b. Small shelf c. Large shelf
58