Okay PCS 5046 Manuel D'utilisation page 71

Keep the file position as illustrated.
After every cutter has been set, check the depth gauge
and file it to the proper level as illustrated.
WARNING
Be sure to round off the front edge to reduce the chance
of kickback or tie-strap breakage.
Make sure every cutter has the same length and edge
angles as shown below.
GB | Operating Instructions
Guide bar
• Reverse the bar occasionally to prevent partial wear.
• The bar rail should always be a square. Check for
1) Appropriate
gauge checker
2) Make the shoul-
der round
3) Depth gauge
standard
This saw is equipped with the following low kickback bar/
chain combination:
Guide bar:
PCS 5046 - Oregon 188PXBK095
Saw chain:
PCS 5046: Oregon 21BPX072 X
For replacement use only above bars and chains.
If you use non-approved combinations it may cause se-
rious personal injury and damage to the machine.
15
wear of the bar rail. Apply a ruler to the bar and the
outside of a cutter. If a gap is observed between them,
the rail is normal. Otherwise, the bar rail is worn. Such
a bar needs to be corrected or replaced.
WARNING
4) Cutting length
5) Filling angle
6) Side plate angle
7) Top plate cutting
angle
1) Ruler
2) Gap
3) No gap
4) Chain tilts