Sony BRAVIA VPL-VW70 Mode D'emploi page 63

Symptom
The picture is too dark.
The picture is not clear.
The picture flickers.
The color of characters or
the picture is not
appropriate.
Image is left on the screen.
(image retention)
On-screen display
Symptom
On-screen display does not
appear.
The model name does not
disappear from the screen.
Remote control
Symptom
The remote control does
not work.
Cause and Remedy
c Adjust the "Contrast" or "Brightness" of the Picture
properly. (1 page 46)
c Adjust the focus. (1 page 25)
c Condensation has accumulated on the lens. Leave the projector
for about 2 hours with the power on.
c For pictures from a computer, activate "APA" and adjust the
current input signal.
c Adjust "Phase" for "Adjust Signal" in the Screen
properly. (1 page 51)
c Select the desired color registration in "Panel Alignment" of
Installation menu (1 page 57).
c When high contrast non-moving images are displayed for a long
period of time, there may be some image retention on the
screen. This is only a temporary condition. Turning off the
power for a while will eliminate the retained image.
Cause and Remedy
c Set "Status" in the Setup
c Check if the ON/STANDBY indicator should light in green.
c The display mode of the projector may be set at the time of
purchase. Consult with your local dealer or qualified Sony
personnel.
Cause and Remedy
c Batteries could be weak. Replace them with new batteries.
(1 page 10)
c Insert the batteries with the correct polarities. (1 page 10)
c If there is a fluorescent lamp near the remote control detector, the
projector may work improperly or inadvertently.
c Set "IR Receiver" to "Front & Rear" on the Installation
(1 page 56).
menu to "On." (1 page 52)
menu
menu
menu
63
GB