Onkyo TX-8220 Mode D'emploi page 22

> Before Start > Part Names
OPTICAL jacks. If you do not assign a jack, select "----".
CD Assign a desired DIGITAL IN COAXIAL jack or DIGITAL IN
OPTICAL jack to the "CD" input selector. (Default Value is
"COAX")
BD/DVD Assign a desired DIGITAL IN COAXIAL jack or DIGITAL IN
OPTICAL jack to the "BD/DVD" input selector. (Default Value is
"----")
CBL/SAT Assign a desired DIGITAL IN COAXIAL jack or DIGITAL IN
OPTICAL jack to the "CBL/SAT" input selector. (Default Value is
"----")
LINE Assign a desired DIGITAL IN COAXIAL jack or DIGITAL IN
OPTICAL jack to the "LINE" input selector. (Default Value is
"----")
TV Assign a desired DIGITAL IN COAXIAL jack or DIGITAL IN
OPTICAL jack to the "TV" input selector. (Default Value is "OPT")
0 "----" cannot be selected for "TV".
0 Supported sampling rates for PCM signals (stereo, mono) from a digital input are 32 kHz,
44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz/16 bit, 24 bit.
SP Impedance
Set the impedance (≠) of the connected speakers.
"4 ohm": When any of the connected speakers have 4 ≠ or more to less than 6 ≠ impedance, or
when speaker systems are connected to both of the SPEAKERS A/B terminals
"6 ohm (default value)": When the connected speakers all have 6 ≠ or more impedance
0 Note that when connecting to both SPEAKERS A and B terminals, connect speakers with
8 ≠ to 16 ≠ impedance to both A and B.
0 For impedance, check the indications on the back of the speakers or their instruction
manual.
Tuner Setting
The setting cannot be selected when input other than TUNER is selected.
22
> Install > Playback
Preset Write You can register up to 40 of your favorite radio stations. While
the preset number is flashing (about 8 seconds), repeatedly
press the cursor Left/Right buttons on the remote controller to
select a number between 1 and 40.
Preset Erase Delete a registered preset number.
0 This setting is not available if you have not selected a preset
number.
Name Edit Set simple names for the stations you have preset. The set
name will be shown on the main unit display. To name a preset
radio station, press TUNER on the remote controller, select AM
(North American models)/FM and select the preset number.
(Preset names cannot be given to DAB stations.)
For details on how to enter text, refer to "Naming Radio Stations
Registered as Presets" (P19).
0 This setting is not available if you have not selected a preset
number.
Tuning Mode Switches tuning to AM (North American models)/FM automatic
tuning/manual tuning.
"Auto (default value)": Tuning Automatically.
"Mono": Tuning Manually.
Search Level 0 If automatic tuning regularly stops on FM stations with weak
(European models) reception when "Normal (default value)" is selected, select
"Strong" so only those FM stations with strong reception are
selected.
Station Order Change the order stations are displayed:
(European models) "Alphabet (default value)": Sort stations alphabetically.
"Multiplex": Sort stations by multiplex.
0 The setting cannot be selected when an input other than DAB
is selected.
DAB Auto Scan You can run the auto scan when new DAB stations are added or
(European models) when you move house.
0 The setting cannot be selected when an input other than DAB
is selected.
Setup | Others