Daily Use - Jøtul F 470 SHD Serie Manuel D'installation Et D'utilisation

ENGLISH
4.9 Location of approval label
The approval label must always be affixed to the wire and
positioned as illustrated in Fig. 23 A.
Fig. 23, Base
Fig. 23, Pedestal
Fig. 23, Foot
NB! Note that, on the foot, the approval label A must be pushed
in onto the clip B with the text turned downwards.
16

5.0 Daily use

Odours when using the fireplace for the first time
When the fireplace is used for the first time, it may emit an
irritating gas which may smell slightly. This happens because
the paint dries.The gas is not toxic but the room should be
thoroughly ventilated. Let the fire burn with a high draught until
all traces of the gas have disappeared and no smoke or odours
can be detected.
Heating advice
NB: Logs that have been stored outdoors or in a cold room should
be brought indoors 24 hours before use to bring them up to room
temperature.
There are various ways of heating the stove but it is always
important to be careful about what you put in the stove. See the
section on "Wood quality".
Important! An inadequate air supply can lead to poor combustion,
high emissions and a lower level of efficiency.
Wood quality
By quality wood we mean most well-known types of wood such
as birch, spruce and pine.
The logs should be dried so that the moisture content is no more
than 20%.
To achieve this, the logs should be cut during the late winter. They
should be split and stacked in a way that ensures good ventilation.
The wood stacks should be covered to protect the logs from rain.
The logs should be brought indoors during early autumn and
stacked/stored for use in the coming winter.
Be especially careful never to use the following materials as fuel
in your fireplace:
• Household rubbish, plastic bags, etc.
• Painted or impregnated timber (which is extremely toxic).
• Laminated wooden planks.
• Driftwood
These may harm the product and are also pollutants.
NB: Never use petrol, paraffin, methylated spirit or similar liquids
to light the fire. You may cause serious injury to yourself and
damage to the product.
Kindling (finely split wood):
Length:
Diameter:
Quantity required each time: 6 - 8 pieces
Wood (split wood):
Recommended length:
Diameter:
Interval for adding wood:
Fire size:
Quantity required each time: 2
Nominal heat output is achieved when the air vent is open
approx. 50% (Fig. 22 A) and the handle for the ignition vent
(Fig. 22 B) is closed.
approx. 30 cm
2-5 cm
20 - 30 cm
Approx. 8 cm
Approx. every 45 minutes
1,6 kg (nominal output)