Sony Handycam HDR-CX250 Mode D'emploi page 24

To turn off the power
Close the LCD screen or press the POWER button (p. 15).
To adjust the angle of the LCD panel
First open the LCD panel 90 degrees to the
camcorder (), and then adjust the angle
().
To turn off the beep sound
 [Setup]  [
Select
Notes
The recording date, time and condition, and coordinates (HDR-CX260V/CX580V/PJ260V/PJ580V/

PJ600V/XR260V) are recorded automatically on the recording media. They are not displayed during
recording. However, you can check them as [Data Code] during playback. To display them, select
 [Setup]  [
Once the clock is set, the clock time is automatically adjusted with [Auto Clock ADJ ] and [Auto Area

ADJ] set to [On]. The clock may not be adjusted to the correct time automatically, depending on the
country/region selected for your camcorder. In this case, set [Auto Clock ADJ ] and [Auto Area ADJ] to
[Off] (HDR-CX260V/CX580V/PJ260V/PJ580V/PJ600V/XR260V).

[Power On By LCD] (p. 69)

To set the date and time again: [Date & Time Setting] (p. 69)

To calibrate the touch panel: [Calibration] (p. 82)

US

 180 degrees (max.)
General Settings]  [
Playback Settings]  [Data Code]  [Date/Time].
 90 degrees (max.)
 90 degrees to the camcorder
]  [Off].
Beep