Publicité
WiPro „all in one" Installation manual
1.9.2 Installing the wireless contacts
Choose the places where you want to install the contacts. The distance between
the transmitter (Diagram 3, Part A) and magnet (Diagram 3, Part B) can be
around 22 mm. A larger distance activates the transmission process (LED briefly
lights up Diagram 4, C) and triggers the alarm when the system is activated.
B efore installing the magnetic contacts, carry out a range test using the
adhesive pads on the back.
I n order to do so, fix the transmitter which is already assigned and the magnets
to the places you have chosen using adhesive tape and follow the instructions
under 1.9.3.
Only use motif adhesive pad (Spare part item no: THZ-1-00002) for smooth
surfaces (glass / acrylic etc.). For all other surfaces, only use the white
adhesive pad (Spare part Item no: THZ-1-00003).
The contact surface must be clean, dry and free of grease. Treat beforehand
GB
with suitable cleaning agent.
Do not use on surfaces at temperature below 15°C.
The adhesive pads reach their final strength after approx. 24 hours.
If installed on the rear storage locker, use the mounting adapter (art.
no. THZ-1-00004) to optimize the transmission and bridge larger gaps.
1.9.3 Range test/ Diagnostics mode
B riefly press the button "A" on the central unit (Diagram 2 Page 6). The red LED
starts to flash (Diagram 2, Part C). WiPro is now in Diagnostic mode.
If there is no acoustic cancel tone, the transmitter is not assigned (repeat 1.8)
or shielded by metal parts. In this case, choose another place to mount the
transmitter or use mounting angles (Item no.: THZ-1-00004)
T o terminate Diagnostics mode, briefly press the button "A" again.
The LED goes out.
1.9.4 Installing the wireless gas alarm (accessory)
Choose a suitable place to mount the wireless gas alarm.
The place where it is mounted should not be in the direct vicinity of the heater
outlets or where there are lead-acid batteries. Mounting it in the direct vicinity
of strong cleaning agents, petrol and other fuels should also be avoided.
The ideal height of installation is at the lowest point of the vehicle
just above the floor (approx. 10-20 cm).
Now carry out a range test with the wireless gas alarm, as described under
1.9.3. Mount the wireless gas alarm using the template in the wireless gas
alarm manual and connect the power supply. (brown = +12V / white = earth)
The central unit cancels every transmission process received
from an assigned transmitter, with an acoustic signal.
Page 7
Publicité
