Publicité
WiPro „all in one" Installation manual
1.6 Preparing for installation
Make sure you have the tools and materials listed below:
- Cross-head screwdriver
- Crimping pliers
- Voltmeter
- Cordless screwdriver
- 8 mm drill bit
- Socket set
- Insulating tape
- Butt connectors
- Ring terminals
- Cable ties
- Shrink sleeve if necessary
- Cleaning cloth for degreasing
- Cleaning agent or degreaser
Choose a suitable place for installing the central unit, siren,
wireless magnetic contact(s) and other accessories.
All accessories such as handheld transmitters, further contacts, wireless gas
alarms and cable loops should be stored before they are installed. (see 1.8)
1.7 Adjusting WiPro to the vehicle type
Open the casing of the central unit (A) by removing the two
crosshead screws (B, C) as shown on Diagram 1 on Page 6.
S et the dipswitches (B) on Diagram 2, Page 6 according to Table 1. If your
vehicle is not on the list or is older, connect it in the usual way (see universal
connection diagram, Page 11) and make sure that all the switches are in
the off position.
The settings must be made with the circuit de-energised. Make sure that
neither the 20-pin plug nor the plug for the GSM module are plugged in.
Table 1
Vehicles from 2006 and later
Fiat Ducato
Citroën Jumper
Peugeot Boxer
Ford Transit
Mercedes Sprinter
VW Crafter
Iveco Daily
Renault Master
Opel Movano
Nissan Interstar
VW T5
Switch 1
Switch 2
off
on
on
on
on
off
off
off
on
on
on
off
Page 4
Switch 3
Switch 4
off
off
off
off
off
off
off
on
on
off
on
off
GB
Publicité
