Specifications - Sony STR-DA3200ES Mode D'emploi

• Make sure you select the correct input on
the remote.
• When you operate a programmed non-
Sony component, the remote may not
function properly depending on the model
and the maker of the component.
Error message
If there is a malfunction, the display shows
a code of two numbers and a message. You
can check the condition of the system by the
message. Refer to the following table to
solve the problem. If any problem persists,
consult your nearest Sony dealer.
PROTECTOR
Irregular current is being output from the
speakers, or the upper panel of the receiver
is covered with something. The receiver will
automatically turn off after a few seconds.
Check the speaker connection and turn on
the power again.
Reference sections for clearing
the memory
To clear
All memorized settings
Customized sound fields
124
GB

Specifications

AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 120 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
POWER OUTPUT
Rated Power Output at Stereo Mode
Reference Power Output at Stereo Mode
Reference Power Output
See
page 39
page 81
Reference Power Output
1)
2)
(8 ohms 20 Hz – 20 kHz,
THD 0.09%):
120 W + 120 W
(4 ohms 20 Hz – 20 kHz,
THD 0.15%):
120 W + 120 W
(8 ohms 1 kHz, THD 0.7%)
FRONT
130 W + 130 W
CENTER
130 W
SURROUND
130 W + 130 W
SURROUND BACK
130 W + 130 W
(4 ohms 1 kHz, THD 0.7%)
FRONT
130 W + 130 W
CENTER
130 W
SURROUND
130 W + 130 W
SURROUND BACK
130 W + 130 W
Depending on the sound field settings and the
source, there may be no sound output.
Measured under the following conditions:
Power requirements: 120 V AC, 60 Hz
1) 2)
2)
2)
:
2)
:
2)
:
2)
:
2)
:
2)
:
2)
:
2)
: