Electrical Components - Astralpool 27586-30899 Manuel D'installation Et D'entretien

6. ELECTRICAL COMPONENTS

To guarantee electrical safety, the equipment is provided with an electrical unit that is protected against the inlet of water. If
a cable or any of the components are damaged, the whole electrical unit should be changed.
None of the components of this electrical unit should be handled, as it would affect the safety of the equipment.
REPLACING THE ELECTRICAL UNIT
If a cable or a component of the electrical unit is damaged, proceed as follows:
• Disconnect the apparatus from the mains.
• Dismantle the apparatus from the swimming pool and remove.
• Disconnect the motor from the body unit at the bottom of the apparatus and remove.
Skim-filter 27586 - 27587
When replacing the electric unit, please note that there is a screw beside the motor, as indicated in Fig. A. This screw
should never be tightened any further. It is a safety screw to prevent children from removing the motor.
To remove the motor, turn the skim-filter so that it is easier to work. First completely loosen the screw (Fig. B) and then
remove the motor making a quarter turn towards the right, taking care to lift the flap (Fig. C) to correctly remove the motor.
To place the motor back in the skim-filter, the motor should first be inserted turning to the left and then tightening the
screw back to its original position.
Place the new motor and fasten it to the body unit.
Fig. A
Skim-filter 30899 - 30943
Unscrew the 3 screws that hold the motor and remove the electric/motor unit.
Place the new electric/motor unit by tightening the 3 screws to the body of the skimmer and place the bottom cover by
tightening the 3 corresponding screws
• Reassemble the equipment in the pool following the instructions given in the INSTALLATION section of this manual.
7. WINTER – MAINTENANCE WHEN OUT OF USE
To ensure that the equipment is well preserved, it should be stored during winter or during long periods when it is not used.
To do this, dismantle it from the pool, clean the filter and dry all the components with a soft cloth or absorbent paper so that
it is not scratched. It is recommended to store the equipment in its original packaging and in a dry place. It is advisable to
use this opportunity to visually check the state of the cable and other electrical components and replace if necessary. To do
this, follow the instructions indicated in the section ELECTRICAL COMPONENTS.
After the winter, install the equipment as if it were new.
8. WINTER – MAINTENANCE WHEN OUT OF USE
Place the transformer to a minimum distance of 3.5m from the edge of the swimming pool.
•
Electrical installations should only be performed by professional installers qualified in electrical installations.
•
The apparatus should not be on while the swimming pool is being used.
•
Do not operate the apparatus without water.
•
People should NEVER touch the apparatus when it is on if they are wet or with wet hands.
•
DISCONNECT the apparatus from the mains before handling.
•
Ensure that the ground is dry before touching the electrical equipment.
•
Never place the apparatus where it could become wet, as this could cause electrocution.
•
Do not allow children or adults to lean against or sit on the apparatus.
•
Never use the apparatus for more than 4 consecutive hours.
•
If the flexible power supply cable of the apparatus is damaged, it should be replaced. Read instructions how to replace it
•
carefully. If in doubt, consult your technical service.
The Skim-filter drives little water.
The Skim-filter does not filter,but it does add water to the pool. Verify that the cartridge cover is properly installed.
The Skim-filter does not move the water.
The Skim-filter returns dirty water to the swimming pool.
If you cannot solve the problem, contact the pool manufacturer.
PROBLEMS
Fig. B
The cartridge is dirty. Clean it.
Verify the connection, and that there is voltage supply to
the outlet.
Verify that the cartridge is in good condition and properly
installed.
5
Fig. C
SOLUTIONS