General Characteristics - Astralpool 27586-30899 Manuel D'installation Et D'entretien

2. GENERAL CHARACTERISTICS:

This Skim-filter has been designed for use in fresh water pools. It is a Class I electric apparatus which complies with the IPX8
degree of protection (resistance to penetration of dust, solid bodies and humidity).
CONNECTION OF APPARATUS
Connect the transformer to a 230V 50 Hz source of alternating current which is equipped with a single-pole switch, so that
the apparatus does not receive any voltage when it is not in use, and a 30 mA differential for discharge protection.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric components
which have been inserted or handled at locations other than its own premises.
3. INSTALLATION:
This equipment is easy to install and can be assembled by AN ADULT in around ½ HOUR, taking care to correctly follow the
instructions detailed in this manual at all times.
Place the Skim-filter facing the dominant winds, so that these help to carry the dirt which remains on the surface of the pool
towards the filter.
The transformer should be located at least 3.5 m from the edge of the pool (Fig. 2).
INSTALLATION OF SUPPORT FOR SHEET SWIMMING POOL OR TUBULAR
Insert the support arm in the housing for the support clamp of the Skim-filter (Fig. 3).
Insert the feed cable in the housings on the inside of the support arm of the Skim-filter. Ensure that it is firmly secured.
Place the Skim-filter unit and the plastic support unit on the edge of the swimming pool (Fig. 4).
Place the two nuts in the housings of the support sealing clamp.
Insert the two screws from inside the swimming pool and tighten them firmly.
Balance the apparatus so that it is level on the vertical plane.
Attention: the distance of the locking pin can be increased with the two distance spacers that are supplied in a bag (No 6)
with two screws. These screws are longer than those already bolted, in order to bolt the locking pin to the distance spacers.
INSTALLATION OF SUPPORT FOR SELF-SUPPORTING SWIMMING POOL
Insert the rod for self-supporting swimming pools in the housing of the support clamp for the Skim-filter (Fig.3)
Secure the rod with both rod securing units.
Place the Skim-filter unit and the support rod on the edge of the swimming pool (Fig. 4).
Balance the apparatus so that it is level on the vertical plane.
27587
30943
3
27586 27587
30899 30943
27586
30899