Texas Power Split 2100 V Guide D'utilisation page 27

Step 4:
Attach Engine and the Oil Pipe
1. Attach the engine (#11) to the
wheel stand using polyurethane
block (#12) and large flat washer
Ø10 (#58), hex bolt M8x65
(#36),flat washer Ø8(#37), lock
washer Ø8 (#57), hex lock nut M8
(#38).
2. Attach the clear oil pipe (#43) to
the gear pump oil inlet connector,
positioning by clamp (#44).
3. Attach the high pressure oil pipe
(#39) to the gear pump oil outlet
connector, sealing with O ring
Ø11.2x2.4 (#32).
4. Attach hydraulic hose (#42) to
hydraulic reservoir connector,
sealing with O ring Ø11.2x2.4
(#32).
Note: Tighten hydraulic hose
connector between torque of 80-
90N·m. Adjust the hydraulic hose
to a non-kinked state and the
connector should be upright.
Step 5:
Electric Breaking Switch
1. Attach two wires of engine to the
electric breaking switch and tighten
with two bolts.
Note: There's no difference
between the two wires.
27