System Consumption; Zone Settings - Airzone FLEXA 3.0 Manuel D'utilisation

System consumption

This menu displays information about the amount of time of air demand of the zone
and also about the operation of the AC unit of the system during the day.
If your system provides information on the electrical consumption, it will display the
current power of the unit and the accumulated consumption during the day.
EN

Zone settings

From this menu you can act on:
Sleep Mode: The Sleep mode works as an auto power-off Eco-timer of the
zone. These are the values you can select:
• OFF. The timing is off.
• 30. It activates the timing and switches off the zone after 30 minutes.
• 60. It activates the timing. After 30 minutes, the zone varies one degree its
temperature. After 60 minutes, the zone will switch off.
• 90. It activates the timing. After 30 minutes, the zone varies one degree
its temperature. After 60 minutes, the zone varies another degree the
temperature. Finally, after 90 minutes, the zone will switch off.
Anti-freezing. It prevents the room temperature from dropping below 12ºC,
although the zone is off. (It will not activate in Stop mode)
Depending on the type of installation and on how you system is configured, there
are some extra functionalities:
Grille angles: It allows you to define the angle of the Airzone grilles of the
zone for cooling and heating modes. It is defined at 90º by default (this option
is not available for plenums).
Control stages: In case of controlling air and radiant in the zone, you can
select which heating option you want to use. It is configured as combined by
default.
Q-Adapt: Select the control algorithm that best fits your installation. These are
the available options:
• Maximum: The system operates at maximum speed, irrespective of the
number of zones.
• Power: The speed of the system is higher than in standard mode to
increase the flow.
11