To Set Up; Preparing Skin For Treatment - Beurer IPL 7500 Mode D'emploi

even if your general skin type is lighter. As an extra pre-
caution, this device only emits a light pulse when it is in
contact with your skin.
Response to the device hair reduction differs among indi-
viduals, depending on biological factors and how closely
treatment instructions are followed. Based on the treatment
regime in these instructions, some results can be seen in
3-4 weeks.
The hair will continue to grow up to two weeks after a treat-
ment session. Since hair grows in three different stages, the
hairs will naturally and gradually fall out depending on the
hair growth stage in which the treatment was done (only
hairs in the active growth stage will be affected). Some hair
may not be affected by the device because of the different
hair growth stages. Continue treatment over a period of time
to ensure hair is treated in the effective stage.
For permanent reduction in hair regrowth, defined as a long-
term, stable reduction in the number of hair regrowing when
measured at 6, 9, and 12 months you should follow treat-
ment regimen.

5. To Set Up

1. Remove all components from the box (handheld device
and power supply).
2. Before beginning the treatment, make sure the device is
clean, dry, and intact.
3. Plug the power supply end into an electrical outlet and
the cord end into the device socket. The device is now
ready to be used.

Preparing Skin for Treatment

1. Before treatment, make sure your skin is shaved, clean,
and dry (free of any residue such as powders, creams,
makeup, antiperspirants, or deodorants).
2. Between treatments, you can shave but do not wax or
pluck treated hair.
3. Never use flammable liquids such as alcohol (including
perfumes, sanitizers, or other applications containing al-
cohol) or acetone to clean the skin for at least one hour
before treatment.
4. Ensure the device is clean and then perform a prelimin-
ary test on a small patch of skin in the intended treat-
ment area 48 hours prior to first full use. This test will
help determine the proper energy level setting for your
skin type (see the "Preliminary Test" section below). The
device is now ready to be used.
• For a prolonged use, device cleaning is a must (see
chapter 6 "Care and maintenance").
12