GINGKO GK16G12 Mode D'emploi page 4

ALARM SETTING INSTRUCTION
The alarm has been initially turned off as a default setting. Please follow the below
instructions to set up your alarm.
NOTE: If you do not select anything for more than 20 seconds the clock exiting the setting
mode and return back to regular display.
● Press and hold down the
the alarm time screen section will show 8:00 first (this is the default alarm time once
the alarm setting has been activated)
● Press ALARM button once again and the HOUR will start flashing, then press + or - to
change the HOUR and press SET to confirm.
● When the MINUTE flashes press + or - to change the MINUTE and then press SET to
confirm.
●
The clock will then give you an option to choose from:- "-Fb-/-bb-"
-Fb- : Radio Alarm (the alarm will go off with Radio)
-bb-: Buzzer alarm (the alarm will go off with a beep sound)
To choose the alarm to wake you up by radio press + or - to select "-Fb-" and press SET

to confirm or to choose the alarm to wake you up with "beep" press + or - to choose "-
bb-" and press SET to confirm.
●
The set alarm time will display on the bottom right & front of the clock and will have a
dot on the bottom right hand corner of the alarm time if you choose to be woken up by
radio.
TOUCH/SOUND ACTIVATION & PERMANENT TIME DISPLAY SETTING INSTRUCTIONS
The sound sensitive function can be turned off so the time can display continuously without
going off but having this function turned on will save energy. The clock can also be set to
display time only without alternating between the date and temperature.
● To turn sound activation function ON press the T/S button and select between the two
options:
- -:Sd = Sound activation ON
oN:Sd = Sound activation OFF
● To set the clock on permanent time display, press and hold down the T/S button when
the clock is not in any setting mode until you hear a beep. To turn it back to the
alternates display, press and hold down the button again.
RADIO OPERATING INSTRUCTIONS
The radio can be turned on only if the clock has been turned on, so please make sure you
will turn on the clock display first before the below operation.
● To turn on the radio press and hold down the aluminium button located on left top of
the radio for 3-5 seconds. The radio frequency will turn on in replace of the alarm time
display (if you have set one)
● Press the aluminium button once to automatically tune the radio channels
● Press the aluminium button twice quickly to activate manual tuning and when the
frequency flashes. Turn the dial clockwise and anti-clockwise to change the frequency
button for 3 seconds to activate the ALARM settings and