GINGKO GK16G12 Mode D'emploi page 2

INSTALLATION
●
Take the Radio clock and wall plug adapter out from the package and place it in a safe
place.
●
Hold down the
instantly light up on the front face of the clock.
● If there is no display coming up, then please connect the wall plug adapter to DC point
at the back of the clock to recharge the clock. While charging, the LED light next to the
DC point should be in red and it will turn into green when it's fully recharged. The
charging should take 3-4 hours.
●
When it's fully recharged, please turn on the clock display and then go to the setting
instructions to set up your Radio Click Clock.
CLOCK CHARGING/BUILT-IN RECHARGING BATTERY INFORMATION
● The clock has been initially fully charged but you may need to recharge it again before
your first time use. The battery should last around 7-10 days if the clock is in permanent
display mode and approximately 2-3 months in sound activation display mode.
However, while the Radio is in use, the battery would last about 5-7 hours but it also
depends on radio volume while it's playing.
● The LED display will become more dim or the LED numbers may start flashing or shaking
when the Radio is on, which means the battery is low and you will need to recharge the
clock as soon as possible.
●
Please only use the DC/AC adapter included with the clock to charge the clock.
● Charging time can take up to 3-4 hours. You may need to remove the charger if you only
want the battery to power the product when it's fully recharged.
● However, you can also use the charging DC adapter to power the clock and you can
leave the adapter permanently plugged in. When the clock is permanently plugged in, it
will take power from the plug adapter instead of the battery and while the adapter has
been removed it, it will then take the power from the built-in rechargeable lithium
battery.
●
We strongly advise you to set the clock on sound activation display if it's powered by
battery, so the battery will last much longer than the permanent display setting.
OPERATING BUTTON SYMBOLS INTRODUCTION
SET: To access the settings mode
+: To scroll up to the number when in setting mode.
-: To scroll down in settings mode.
T/S: To activate and deactivate the touch or sound function
: To activate the alarm settings
: Switches the product on or turns it off
ENGLISH
button for 3-5 seconds to turn on the clock, the LED display should