Xenteq LBC 500S Serie Manuel page 15

E N
INTRODUCTION
On page 54 you will find the technical specifications of the LBC 500S.
Charge status
Connector for (optional)
temperature sensor
2 functions:
Overview charge setting
-
Display error message
-
The LBC 500S is a fully automatic battery charger and float charger in one and
can be left
microprocessor supervises the battery and the charge process continuously so
that a very safe and accurate process can be guaranteed. The internal
electronics comes
exceptionally intelligent battery charger.
The LBC 500S can be used for a large diversity of battery types, such as
Starting, semi-traction, traction, GEL, AGM, Calcium, Spiral and LifoPo4. The
charger is suitable for many battery types because the charge voltages can be
set. See chapter 'SETTING THE CHARGER', section 'charge voltages'.
During the charge process, and also when the charger is in its float stage,
potential users may be turned on. The charger will indirectly supply the present
consumers and the battery is spared. Keep in mind that when charging a
(partially) empty battery, the current draw of the present consumers comes at
the expense of the charge current for the battery. If you only want to use the
charger as a power supply, then put the charger in its power supply mode, see
chapter 'SETTING THE CHARGER' section 'charger as power supply'.
You can use multiple power sources, like solar panels or a dynamo, together
with the LBC 500S battery charger.
15
connected to the
from the latest
Connection to battery
mains power supply
developments,
Charger status
3 functions:
Setting the charger
Turning charger on/off
Request error
permanently.
which resulted in
The
an