Xenteq LBC 500S Serie Manuel page 14

QUICK GUIDE
This Quick Guide contains only basic instructions for use of this battery charger.
Always read the complete manual so that the charger's operation and features
are clearly understood to ensure proper use of the charger.
For initial use, set the charger to the correct charging voltages. See the
manual.
If you are using the optional temperature sensor T-Sense1, this must first be
activated. See the manual.
Fit and install the charger according to the instructions
The charger may feel warm during the charging process, this is normal.
Charging the battery
Connect the charger to the battery: the red cable to the + pole and the black
cable to the - pole.
Plug the power cord into a working mains power socket, or connect 230Vac to
the system which the LBC is part of. The green power LED illuminates.
The charger will now start a new charging process. The red LED under 'charge
process' will illuminate. If the green light under 'charge process' illuminates or
flashes, then the charging process has finished.
If an error occurs during the charging process, the red 'power' LED will
illuminate. Finding the problem is easy. To do this, please refer to the
troubleshooter in the manual. In the event of other errors or malfunctions, also
consult the troubleshooter.
The battery charger can remain permanently connected to the 230VAC and
to the battery. The charger will automatically start a new charging process
when necessary.
Starting a new charge or terminating the charge is possible by either
connecting/disconnecting the battery or by switching the mains power on/off.
If necessary, the charger can be switched off manually (standby) by pressing
and holding the power/mode button on the front for 2 seconds. For more
information, please see the manual.
E N
14