Safety Information - Facom NU-711A Manuel D'utilisation

EN
WARRANTY
This instrument is warranted to be free from defects in material and workmanship
for a period of one year. Any instrument found defective within one year from
the delivery date and returned to the factorywith transportation charges prepaid,
will be repaired, adjusted, or replaced at no charge to the original purchaser. This
warrantydoes not cover expandable items such as batteryor fuse. If the defect has
been caused bya misuse or abnormal operating conditions, the repair will be billed
at a nominal cost.

SAFETY INFORMATION

This meter has been designed according to IEC-61010 concerning electronic measuring
instruments with a measurement category (CAT III 600V) and pollution degree 2.
Warning
To avoid possible electric shock or personal injury, follow these guidelines:
• Do not use the meter if it is damaged. Before you use the meter, inspect the case.
Pay particular attention to the insulation surrounding the connectors.
• Inspect the test leads for damaged insulation or exposed metal. Check the test leads
for continuity. Replace damaged test leads before you use the meter.
• Do not use the meter if it operates abnormally. Protection may be impaired. When
in doubt, have the meter serviced.
• Do not operate the meter around explosive gas, vapor, or dust.
• Do not apply more than the rated voltage, as marked on the meter, between
terminals or between any terminal and earth ground.
• Before use, verifythe meter's operation by measuring a known voltage.
• When measuring current, turn off circuit power before connecting the meter in the
circuit. Remember to place the meter in series with the circuit.
• When servicing the meter, use only specified replacement parts.
• Use caution when working with voltage above 30V ac rms, 42V peak, or 60Vdc. Such
voltages pose a shock hazard.
• When using the probes, keep your fingers behind the finger guards on the probes.
• When making connections, connect the common test lead before you connect the
live test lead. When you disconnect test leads, disconnect the live test lead first.
• Remove the test leads from the meter before you open the battery cover or the case.
• Do not operate the meter with the battery cover or portions of the case removed or
loosened.
• To avoid false readings, which could lead to possible electric shock or personal
injury, replace the battery as soon as the low battery indicator ("
• Do not use the meter in a manner not specified bythis manual or the safety features
of the meter may be impaired.
• When in Relative mode (the symbol "
(the symbol " " is displayed), caution must be used because hazardous voltage
may be present.
• Do not touch any naked conductor with hand or skin.
14 14
")appears.
" is displayed) or in Data Hold mode