Installing Batteries; Place The Base Station And Remote Sensor - ThermoPro TP-63A Manuel D'instructions

If the low battery icon for remote sensor appears, please
charge the remote sensor as soon as you can.
EN

Installing Batteries

1. Base station: open the battery compartment of the base
station and insert two "AAA" batteries with correct
polarity.
2. Remote sensor: A built-in rechargeable lithium battery is
installed in the remote sensor. Although there could be
some power in the rechargeable battery before the unit
leaves the manufacturing facility, it is always good to
fully recharge the remote sensor before using by
following the steps below:
Note, the package does not INCLUDE a wall adapter.
Simply use any cellphone wall charger with USB socket to
-12-
charge the battery.
a. Connect the charger to the charging socket located on
the back of the remote sensor;
b. Plug the charger into a standard AC outlet;
c. The red light on the remote sensor will light up;
d. Charge it for at least 4 hours until the light changes from
red to green which indicates charging is complete.

Place the Base Station and Remote Sensor

1. The indoor base station (receiver) should always be
placed in a well ventilated indoor area and located away
from vents, heating or cooling elements, direct sunlight,
windows, doors, or any other openings.
2. The remote sensor (transmitter) can be placed on a flat
-13-
EN