Safety Features; Technical Service; Safety Instructions; Important Safety Information - Campbell Hausfeld XT200000 Instructions D'utilisation

SAFETY FEATURES

•
•
STORAGE
Lubricate your cut-off tool before storing. Follow the air motor lubrication
instructions with an exception to step #5. Only run the impact wrench for
2-3 seconds (instead of 10 seconds) because more oil needs to remain in the
impact wrench when storing. Store your tool in a cool dry place.

TECHNICAL SERVICE

For information regarding the operation or repair of this product, please visit
www.campbellhausfeld.com.

SAFETY INSTRUCTIONS

This manual contains information that is very important to know and
understand. This information is provided for SAFETY and to PREVENT
EQUIPMENT PROBLEMS. To help recognize this information, observe the
symbols found on page 8. The Safety Symbols throughout this manual are to
alert you to important safety hazards and precautions.
With any piece of equipment, new or used, the most important part of its
operation is SAFETY!
Campbell Hausfeld encourages you to familiarize yourself with your new
equipment and stresses safe operation.
The next few pages of this manual are a summary of the main safety aspects
associated with this unit. Be sure to read and understand completely before
operating the machine.
The symbols used throughout the operation and maintenance sections of
this manual call attention to safety procedures.

Important Safety Information

Please read and save these instructions. Read carefully before attempting to
assemble, install, operate or maintain the product described. Protect yourself
and others by observing all safety information. Failure to comply with
instructions could result in personal injury and/or property damage! Retain
instructions for future reference.
This cut-off tool is equipped with a fully rotating guard. Reposition the
guard, as needed, to provide the most protection.
The trigger on this tool requires 2-steps to activate the cutting wheel
motor. You must push the trigger latch towards the cutting disc to allow
the trigger to depress and activate the cutting wheel.
The DANGER, WARNING, CAUTION, and NOTICE notifications
and instructions in this manual cannot cover all possible condi-
tions and situations that may occur. It must be understood by
the operator that caution is a factor which cannot be built into
this product, but must be supplied by the operator.
5