Set Up Instructions - Campbell Hausfeld XT200000 Instructions D'utilisation

GETTING TO KNOW YOUR UNIT
Cap Screw
Cutting
Disc/Wheel
14 mm (Arbor) wrench
5 mm Allen wrench

SET UP INSTRUCTIONS

* Items shown in Set Up Instructions are not included with this tool.
u The air compressor used with your cut-off must be able to maintain a minimum of
90 PSI when the tool is being used. An inadequate air supply can cause a loss of
power and inconsistent tool output/performance.
u A pressure regulator—used at the tool—is helpful to control the operating
pressure of the tool and maintain 90 PSI.
u Use an oiler to provide oil circulation through the tool and a filter to remove liquid
and solid impurities which can rust or "gum up" internal parts of the tool.
u To disconnect a coupler/plug from a system set-up: push the coupler and plug
together before pulling the coupler sleeve back and separating the coupler and
plug.
Guard
Arbor
Air Hose
BEST PRACTICES
Air Regulator Adjustment Screw
Trigger Latch
Trigger
Quick
Coupler
3
Air Inlet
Exhaust Port
Plug