Installation Instructions - Siemens DO0570C Notice De Montage Et D'utilisation

Congratulations on purchasing this Siemens appliance. You
have acquired a top-quality product, which will give you a lot
of enjoyment.
Please read this installation and operating instruction
manual carefully, then act accordingly! Store for future
reference.

Installation instructions

Unpacking
Inspect the new appliance for transport damage!
■
Please dispose of the packaging, and if applicable, the old
■
appliance in an environmentally-friendly manner.
I. Scope of delivery
1 Appliance with operating panel
2 Installation bracket
3 Mounting (2 screws, 2 wall plugs)
4 Documentation
Product description
The small water heater is only suitable for open (unpres-
surised) installation. It heats and stores drinking water up to
approx. 85 °C. Different temperature levels can be selected
with the temperature selector knob.
The appliance may not be operated with pre-heated water,
as otherwise the safety temperature limitation will trip.
The appliance is connected using the mains plug.
Preparations for installation
Shut off the water supply before connecting the appli-
■
ance.
Do n o t insert the mains plug.
Remove the installation bracket on the appliance and break
■
off the retaining rings (A).
Fix the connection cable to the rear of the appliance to suit
■
the required length (B).
Wall mounting
II.
Align the appliance on the wall and use the three indents
■
(top, left and right on the appliance) to apply markings
(C).
Connect the markings by a pattern of crossed lines with a
■
spirit level (D1 and D2).
Place the installation bracket on top at the point of inter-
■
section of the drawn lines and mark the position for the
holes (E).
Drill the holes and insert wall plugs (F1).
■
Attach the installation bracket (notch at top) to the wall
■
using the screws (F2).
Suspend the appliance in the installation bracket (F3).
■
8
en
Exchanging appliances
When replacing an old Siemens small water heater with this
new appliance, the existing drill holes with wall plugs can
be used. Please note that the new appliance is approx. 2 cm
higher.
If the new appliance is to be flush at the top like the old ap-
pliance (G1):
Attach the new installation bracket to the wall with the
■
notches at the top.
If the new appliance is to be flush at the bottom like the old
appliance (G2):
Turn the installation bracket around and attach to the wall
■
with the notches at the bottom.
Water connection
III.
Caution!
■
The existing fitting may not be covered with scaling.
Do not grease the thread!
■
Info: Replacement for damaged threaded nozzles available
from customer service.
Fit the taps if required (A1 and A2).
■
Insert the seals (B1).
■
Ensure the axial fit of the connection pipes in the nozzles.
■
Place the union nuts on the thread and tighten them by
■
hand (B2).
Tighten the screw fitting (C). Counter the threaded
■
nozzles on the warm water heater with a wrench
After the unit has been used to heat water a few times,
■
retighten the screw fitting.
Set the flow to 5 l/min (= 1 l in 12 seconds) on the corner
■
valve.
First start-up
Electrical connection
Important: Do not insert the plug into the mains socket yet.
■
Fill the appliance with water first. Water must flow from
■
the fitting.
Only then insert the plug into the mains socket.
■
Note: If the appliance is not filled with water, the resettable
safety temperature limitation will trip!