Important Information; Robot Battery Installation; Remote Battery Installation; Warning - THINK GIZMOS TG542 ROBO SHOOTER Mode D'emploi

1. IMPORTANT INFORMATION

1.1 Robot Battery Installation

The robot takes four AA 1.5v Batteries.
(not included).
a) Using a screwdriver loosen the
screw on the battery compartment.
b) Insert four AA 1.5v batteries making
sure you follow the designated + -
signs.
c) Close the battery compartment.

1.2 Remote Battery Installation

The remote control takes two AA 1.5v
batteries. (not included).
a) Using a screwdriver loosen the
screw on the battery compartment.
b) Insert two AA 1.5v batteries making
sure you follow the designated + -
signs.
c) Close the battery compartment.

1.3 Warning

1. Please do not try and recharge batteries always replace them.
2. Incorrect use of batteries may cause damage, so please pay attention to the following:
● Do not install batteries with opposite polarity.
● When not in use, please switch to 'OFF' position and if the robot is not going to be used
for a long time, please remove the batteries to avoid corrosion.
● Do not mix old and new batteries.
● Please replace exhausted batteries as soon as possible.
● Keep batteries away from children.
● Do not place batteries near fires or expose them to strong sunlight or damp conditions.
● Please dispose of batteries carefully.
3. Don't aim the discs at people or animals.
4. Careful with small parts, do not eat.
5. Do not place near fire, high temperature or damp conditions.
3