Safety Advice; Manual Convention; Important Security Advices; Working With The Transfer Press - SCHUSTER T Serie Mode D'emploi

ENGLISH

1 Safety Advice

Read through following advices before bringing the
transfer press into operation. It is necessary to consider
all warnings and advices indicated on the transfer press.

1.1 Manual Convention

You can find this symbol in particular on
important safety advices in this instruction
manual, in which you will be advised about the
right handling of the transfer press. The notes
next to this symbol need special attention. If not
considered, severe injuries may occur.
It's necessary to pay attention to security
advices which are marked with this symbol. In
case of non observance, burns of the user may
occur. You also can find this symbol marked on
some parts on the transfer press.
A symbol like this advices you, that through
crushing, danger of injuries exists. You also can
find this symbol marked on parts of the transfer
press.

1.2 Important Security Advices

This transfer press
inappropriately, or when used for a non intended use. For
this reason, read carefully all of the following advices:
The transfer press may only be used for
•
printings on pressure- and heat resistant
materials. Every exceeding use is seen as non
intended. If still used for non intended service,
the manufacturer will not be liable for resulting
damages. Unauthorized reconstructions and
modifications are not permitted, because they
will interfere with the security and the service
of the machine.
Don't insert any objects through the case notch.
•
Also make sure that no fluid will reach the
transfer press and the heat element.
The used mains voltage has to be the same as
•
the stated mains voltage on the type plate of the
transfer press.
Watch out not to damage the power plug.
•
If you connect the transfer press over an
•
extension cable, please make sure that the
overall nominal current (of all connected
equipment) does not exceed the allowed current
load. Further make sure that the overall nominal
current of all connected equipment does not
exceed the allowed power supply of the
connected electrical outlet.
presents dangers if
Never try to maintenance the device on your
•
own.
To ensure safe operations of the transfer press,
•
the operator has to make sure that non-
authorized people neither work on the machine,
nor set the machine into operation, or perform
any other operations on the machine.
All operations on the transfer press can only be
•
accomplished by specialised staff who gained
an appropriate instruction or training.
General legal and other binding regulations for
•
accident
protection are to be considered in addition to
this instruction manual.

1.3 Working with the Transfer Press

Look out not to touch the lower part of the heat
•
element while the press is in operation,
otherwise burns may occur. Please also note that
there is still a danger to suffer burns even after
turning off the transfer press for a longer time.
The case of the heat element will also be heating
•
used
up; so be careful!
During the operation of the press, and especially
•
during the start; never put your hand between
the work plate, the heat element, or the transfer
press. Furthermore, make sure that no other
person can reach the transfer press.
Please note following points to prevent damage
•
on the machine and to achieve an optimal print
result.
Objects which (in a pressed condition) are not
thicker than the recommended 5mm and do not
cover the whole work plate; have to be placed
into the center of the work plate. If it is not
possible to centre the object, you have to cover
the empty spaces with pads (of the same size).

2 Check Shipment

TP-54 Solo with a
single sliding table
1 x silicone foam pad
1 x protective cover
1 x hexagon wrench
button
1 x instruction manual
- 12 -
TP-54 Solo / TP-54 Twin
prevention and environmental
TP-54 Twin with a
double sliding table
2 x silicone foam pads
2 x protective cover
1 x hexagon wrench
button
1 x instruction manual