Safety Advice; Manual Convention; Important Security Advices; Working With The Transfer Press - SCHUSTER S Série Mode D'emploi

ENGLISH

1 Safety Advice

Read through following advices before bringing the
transfer press into service. It is necessary to consider all
warnings and advices indicated on the transfer press.

1.1 Manual Convention

You can find this symbol in particular on
important safety advices in this instruction
manual, in which you will be advised about the
right handling of the transfer press. It is
necessary to pay attention to these advices.
Non-observance can lead to injuries of the user.
Security advices which are marked with this
symbol, it's necessary to pay attention to. In
case of non observance, burns of the user may
occur. You also can find this symbol marked on
some parts on the transfer press.
A symbol like this advices you, that through
crushing danger of injuries exists. You also can
find this symbol marked on parts of the transfer
press.

1.2 Important Security Advices

This transfer press
inappropriately, or when used for a non intended use. For
this reason, read carefully all of the following advices:
The transfer press may only be used for
printings on pressure- and heat resistant
materials. Every exceeding use is seen as not
intended. If still used for non intended service,
the manufacturers will not be liable for the
resulting
reconstructions and modifications are not
permitted, because they will interfere with the
security and the service of the machine.
Don't insert any objects through the case notch.
Also make sure that no fluid will reach the
transfer press and the heat element.
The used mains voltage has to be the same as
the stated mains voltage on the type plate of the
transfer press.
Watch out not to damage the power plug.
If you connect the transfer press over an
extension cable, please make sure that the
overall nominal current (of all connected
equipment) does not exceed the allowed current
load. Further make sure that the overall nominal
presents dangers if
damages. Unauthorized
current of all connected equipment does not
exceed the allowed power supply of the
connected electrical outlet.
Never try to maintenance the device on your
own.
To ensure safe operations of the transfer press,
the operator has to make sure that non-
authorized people neither work on the machine,
nor set the machine into operation, or perform
any other operations on the machine.
All operations on the transfer press can only be
accomplished by specialised staff who gained
an appropriate instruction or training.
General legal and other binding regulations for
accident
protection are to be considered in addition to
this instruction manual.

1.3 Working with the Transfer Press

Look out not to touch the lower part of the heat
element while the press is in service, otherwise
burns may occur. Please also note that there is
still a danger to suffer burns even after turning
off the transfer press for a longer time.
used
The case of the heat element will also be heating
up; so be careful.
During the service of the press, and especially
during the start of the transfer press, never put
your hand between the work plate and the heat
element, or the transfer press. Furthermore,
make sure that no other person can reach the
transfer press.

2 Check Shipment

SM-54 with a single
sliding table
1 x silicone foam pad
1 x protective cover
1 x hexagon wrench
button
1 x instruction manual
- 12 -
prevention and environmental
with a double sliding
table
2 x silicone foam pads
2 x protective cover
1 x hexagon wrench
button
1 x instruction manual
SM-54