Printing Operation; Exchange Heat Element And Work Plate; Build In And Extend A Heat Element; Build In And Extend A Work Plate - SCHUSTER S Série Mode D'emploi

SM-54

5 Printing Operation

After you adjusted your settings and the temperature was
reached (the light-emitting diode "O.K." will flash) - you
can begin with your printing operations.
1. If you have an SM-54, pull the sliding table out.
2. If you have a , pull the double sliding table to
the left or right until it blocks.
3. Arrange the item and the corresponding artwork
on the work plate.
4. If you have an SM-54, push the sliding table
back into the transfer press until it blocks.
5. If you have a , pull the double sliding table
towards the opposite side until it blocks.
6. Confirm both starter buttons and the same time.
7. The heat element will lower and start the
operation. After the printing time is over, the
heat element will rise automatically and you
will hear a beep.
6 Exchange Heat Element and Work
Plate

6.1 Build In and Extend a Heat Element

Halte-Schraube
Heizplatten-Stecker
- 15 -
Before you start to extend the heat element,
assure yourself that the heat element is cooled
down to room temperature.
1. At first remove the heat element plug. To do so;
you first of all have to loosen the corrugated-
head screw of the heat element plug with a
phillips screwdriver. Remove the heat element
plug from the outlet.
2. Now you have to loosen both retaining screws
of the heat element with a 13-way spanner, and
screw it out for approximately 3-4 mm.
3. Lift the heat element up, and pull it towards
you.
4. To build in a heat element, do the same process
in reversed order.

6.2 Build In and Extend a Work Plate

Halte-Schrauben
Loose both retaining screws on the underside of the work
plate, then just pull the plate out towards you.
ENGLISH