Set Pressure; Time And Temperatur Controller; Set Temperatur; Set Printing Time - SCHUSTER S Série Mode D'emploi

ENGLISH
The first step to change the pressure will be to pull out
the pressure regulator, then turn the pressure regulator to
the right, to increase the pressure, to the left to reduce it.
After you adjusted the desired pressure, push the
pressure regulator back in to set the pressure.
Usual values for sublimation prints: 3 – 5 bar.
Maximum allowed pressure: 6 bar.
4.3 Time and Temperature Controller
7
4
6
3
Pos. Definition
button „temperature"
1.
button „time"
2.
button „to the right"
3.
button „upwards"
4.
Light-emitting diode „heating"
5.
Light-emitting diode „O.K."
6.
Display „temperature"
7.
Display „time"
8.
1
5
2
8
- 14 -
4.3.1 Set Temperature
1. To set the temperature; push the button
"temperature" once; the first cypher will start
flashing.
Adjust the desired value with the „upwards"
2.
button.
3. To change the value of the second cypher, push
the button „to the right"; and the second cypher
will start flashing. Use the same procedure to
adjust the value.
4. To change the third cypher; use the same
process like for the second cypher.
Push the button „temperature" to save the
5.
settings, as well as to leave the adjustment
mode.
The light-emitting diode will flash "heating", as long as
the temperature set point is not reached yet. After heating
up, the light-emitting diode will flash „O.K." after the
transfer press reached the desired temperature.
Recommended temperature values: 180 – 200 °C

4.3.2 Set Printing Time

Two different printing times can be adjusted:
Push the button „time", and hold it. In the
1.
display „time" (lower display) "t1" (1. time set
point) and "t2" (2. time set point) will flash for
about one second each.
2. To adjust the desired time set point: Release the
button „time", when your desired time set point
(t1. or t2.) is flashing up in the display. Now
only the first cypher should be flashing.
Set the desired value with the button "upwards".
3.
4. To change the second and third cypher, push the
button „to the right". It will flash up. Set the
value like you did with the first cypher.
If you push the button „time"; settings will be saved and
you will leave the adjustment mode.
Acceptable values: 1. time set point:
2. time set point:
45 – 70 sec.
Usual printing time:
SM-54
0-399 sec.
0-60 sec.