Assembling And Bringing Into Service; Settings; Height Adjustment For The Work Plate - SCHUSTER T Serie Mode D'emploi

TP-54 Solo / TP-54 Twin

3 Assembling and Bringing Into Service

1. Unpack the transfer press.
2. Bring the transfer press to it's location of
operation. Only use the assembled transport
device to move the press. Make sure that no
flammable or
equipment are in immediate vicinity of the
transfer press.
3. Remove the transport device. It is very
important to keep them, because the transfer
press can ONLY be moved through these
transport devices. In particular; faults which
will appear when trying to lift the transfer press
up on other parts than the transfer devices, will
be exempted from the warranty. It is especially
unacceptable, to lift the transfer press at the
sliding table or at the heat element. When you
assemble the transport devices, make sure you
plumb in the fixing screws tightly.
4. Remove the corrugated-head screws on the
sliding table. Keep these as well for a further
transport to secure the sliding table against
slipping.
corrugated-head
screw on a single
sliding table
heat-sensitive materials or
corrugated-head
screw on a double
sliding table
5. Connect the power plug with an electrical outlet
and connect the compressed air pipe to the
compressed air filter (see page 11, Fig. 2 and 4).
6. Switch on the power switch to start the transfer
press.
7. The transfer press will be ready for operations
now.

4 Settings

4.1 Height Adjustment for the Work Plate

1
3
1. The first step will be to loosen the locking of
the height adjustments. To do so, turn the clamp
knob to the left.
2. Now turn the work plate in clockwise direction
to lower it, or in anticlockwise direction to raise
it.
- 13 -
ENGLISH
2