Operation; In The Case Of Longer Periods Of Non-Use - Sentiotec A2 Instructions De Montage Et Mode D'emploi

3

Operation

2. Input the desired preselected time- with the plus/minus buttons 7, e.g. [02:30]. The heating will be triggered
in 2 hours and 30 minutes.
3. Confirm preselected time with the START / STOP button 8 The remaining time appears with a flashing point
in the display 4 (preselected time = remaining time until start of heating). When the preselected time has
elapsed, dependent on the type of device, 00.00 or the measured temperature in the range of the temperature
sensor is displayed in the display 4
4. Set the desired sauna temperature in the range 50 – 125 degrees Celsius using the rotary TEMPERATURE
knob 6.
5. To finish:
5.1 Press START / STOP button 8. The sauna heating switches off. 00.00 appears in the display. The HEATING
control light 3 switches off. The control unit is ready to input a preselected time or for a restart.
5.2 Press ON/OFF button 2. The sauna control unit is switched off.
TIP:
The time required for the heating to reach the set temperature varies dependent on sauna size and heater
design.
TIP:
The temperature displayed at the position of the temperature sensor differs very significantly from the
temperature in the lounging area.
4

In the case of longer periods of non-use

Switch off main fuses of the sauna control unit in the fuse box.
WE DO IT FIRST.
Instructions for use for the user P. 11/16
EN