Noise Emission Values; Important Information For Initial Operation; Operation Instructions - erba 33259 Mode D'emploi

GB - INSTRUCTION MANUAL

6. NOISE EMISSION VALUES

~71 dB(A)

7. IMPORTANT INFORMATION FOR INITIAL OPERATION

Environmental conditions: 0° - 40°C, humidity max. 85% at 25°C, not above 1000m sea level
Duty type: e.g.: S³20%-10min means: during a 10 minute period the engine must not be used
more than 20% of the time -> max. 2 min operation and then 8 min cooldown).

8. OPERATION INSTRUCTIONS

Usually the electric hoist is mounted on a steel beam or bar with a diameter of at least 43mm and a
material thickness of no less than 3mm. The beam must be fixed secuely and tightly to a wall. The
wall fixture must be designed in such a way, that it can easily withstand the forces generated by
the operation of the hoist (see technical data). Make sure that the whole installation is inspected by
qualified, certified personnel before you begin to use the product!
To operate the hoist use the up/down switch on the panel (6). Never change direction directly
- always stop the hoist before changing the direction.
If the hoist can not lift a given weight instantly, immediatly stop the hoist and do not try again
to avoid damaging the hoist.
Make sure the load is secured tightly and properly on the hook. Stay away from the load and
the cable during lifting operations.
Please note, that when lowering a given load the reel may have a bit of a follow up movement
after you stop the engine. Take this into account and stop the movement of the hoist accordin-
gly (ie. a little earlier).
Always place the load in the center of the hooks. Do not use the tip of the hooks.
Do not deflect the chain more than 15° and do not scrape the chain over any edges!
When lifting weights start slowly so the chain will gradually straighten and not „snap" into
position. Once the chain is straight and under load, you may increase the speed.
In case of emergency you can stop the hoist by pushing the red button on the controller.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 12
Changes, print, punctuation and other errors reserved!
Instruction manual
33259, 33260
Issue: 09/2019