Noise Emission Values; Important Information For Initial Operation; Operation Instructions - erba 33252 Mode D'emploi

GB - INSTRUCTION MANUAL

6. NOISE EMISSION VALUES

~71 dB(A)

7. IMPORTANT INFORMATION FOR INITIAL OPERATION

Environmental conditions: 0° - 40°C, humidity max. 85% at 25°C, not above 1000m sea level
Duty type: e.g.: S³20%-10min means: during a 10 minute period the engine must not be used
more than 20% of the time -> max. 2 min operation and then 8 min cooldown).
Prior to first use remove the transport lock (the sticker covering the cablereel). Do not try to remove
the sticker using sharp tools - you might damage the steel cable!

8. OPERATION INSTRUCTIONS

Usually the electric hoist is mounted on a steel beam or bar (Fig. 4) with a diameter of at least 43mm
and a material thickness of no less than 3mm. The beam must be fixed secuely and tightly to a wall.
The wall fixture must be designed in such a way, that it can easily withstand the forces generated
by the operation of the hoist (see technical data). Make sure that the whole installation is inspected
by qualified, certified personnel before you begin to use the product!
Prior to first use lubricate the cable with ample amounts of cable-lubricant.
Make sure that the power-switch (10) is in the OFF position and that the steel cable is properly
furled on the cable reel (see fig 2).
Always leave at least 2 windings on the reel. NEVER disengage the killswitches!
To operate the hoist use the up/down switch (10) on the panel. Never change direction directly
- always stop the hoist before changing the direction.
Once the end of the cable becomes visible or the killswitch stops the cable DO NOT unfurl the
cable any further!
If the hoist can not lift a given weight instantly, immediatly stop the hoist and do not try again
to avoid damaging the hoist.
Make sure the load is secured tightly and properly on the hook. Stay away from the load and
the cable during lifting operations.
Please note, that when lowering a given load the reel may have a bit of a follow up movement
after you stop the engine. Take this into account and stop the movement of the hoist accordin-
gly (ie. a little earlier).
Do not deflect the cable more than 15° and do not scrape the cable over any edges!
The furling direction MUST always conform with the direction on the switch. Otherwise the
terminator switches will be circumvented and the hoist may be seriously damaged!
When lifting weights start slowly so the cable will gradually straighten and not „snap" into
position. Once the cable is straight and under load, you may increase the speed.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 14
Changes, print, punctuation and other errors reserved!
Instruction manual
33252,33253,33254,33255
Issue: 10/2020