Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Section
02
Connecting the units
1 Front speaker output (Left)
2 Rear speaker output (Left)
3 RCA input jack A
4 RCA cable (sold separately)
5 From car stereo (RCA output)
One-channel input (Mono)
When connecting a speaker (Bridge)
! Slide INPUT (input) switch to 1CH position.
1 Speaker output
2 RCA input jack A
3 RCA cable (sold separately)
4 From car stereo (RCA output)
Connecting the power
terminal
The use of a special red battery and ground
wire RD-223 (sold separately), is recom-
mended. Connect the battery wire directly to
the car battery positive terminal + and the
ground wire to the car body.
10
En
3
4
1
5
2
2
3
4
1
WARNING
If the battery wire is not securely fixed to the term-
inal using the terminal screws, there is a risk of
overheating, malfunction and injury, including
minor burns.
1
Route battery wire from engine com-
partment to the vehicle interior.
After completing all other amplifier connec-
tions, finally connect the battery wire terminal
of the amplifier to the positive (+) battery
terminal.
1 Positive (+) terminal
2 Engine compartment
3 Vehicle interior
4 Fuse (30 A) × 2
5 Insert the O-ring rubber grommet into the
vehicle body.
6 Drill a 14 mm (1/2 in.) hole into the vehicle
body.
2
Connect the wires to the terminal.
Fix the wires securely with the terminal
screws.
Publicité
Table des Matières
