Sony KLH-W32 Mode D'emploi page 59

For PC Input
: : :
Wide Mode
Auto Adjustment
Phase
Pitch
Horizontal Shift
Vertical Shift
Reset
PAP Setting
Notes
• "Auto Wide", "4:3 Default", "Display Area" and "Vertical Size" are not available for PC input.
• When the input is digital signal via HDMI 1/HDMI 2, "Auto Adjustment", "Phase" and "Pitch" are not available for PC input.
• If there is no signal currently being input, none of the "Screen" settings options, except for "PAP Setting" can be selected.
:
"Normal": Select to display the picture in its original size.
"Full 1": Select to enlarge the picture to fill the display area in the vertical direction
while keeping its original aspect ratio. A black frame will appear on the surrounding
of the picture.
"Full 2": Select to enlarge the picture to fill the display area.
Note
You cannot set the "Wide Mode" while using the "PAP" function.
Select to automatically adjust the display position and phase of the picture when the
display receives an input signal from the connected PC.
Note that "Auto Adjustment" may not work well with certain input signals. In such
cases, manually adjust the options below.
Select to adjust the phase when the screen flickers.
Select to adjust the pitch when the picture has unwanted vertical stripes.
Allows you to move the position of the picture left and right in the window. Press
G/g and press to choose a correction.
Allows you to move the position of the picture up and down in the window. Press
F/f and press to choose a correction.
Resets the following settings; "Phase", "Pitch", "Horizontal Shift" and "Vertical
Shift" to the default settings.
See "PAP Setting" for video input (page 24).
When input is switched to PC input source, the
"Screen" settings specific for PC input are applied.
The PC "Screen" settings include the following
options:
GB
25
GB