Security - Degometal GO 41 Instructions De Sécurité Et Mode D'emploi

2. SECURITY

Anyone installing, using or maintaining this tool should carefully read the following safety rules.
• DO NOT USE FOR ANY PURPOSE OTHER THAN INTENDED.
• DO NOT USE WITH THIS TOOL OR MACHINE ANY EQUIPMENT OTHER THAN THOSE
RECOMMENDED AND SUPPLIED BY DEGOMETAL.
• ANY MODIFICATION MADE BY THE CUSTOMER TO THE TOOL OR MACHINE, NOSE
ASSEMBLIES, ACCESSORIES, OR ANY OTHER MATERIAL PROVIDED BY DEGOMETAL
OR ITS REPRESENTATIVES ARE THE SOLE AND ENTIRE RESPONSIBILITY OF THE
CUSTOMER.
• THE TOOL OR MACHINE MUST BE MAINTAINED AT ALL TIMES FOR SAFE OPERATION,
AND THEIR GOOD CONDITION AND OPERATION MUST BE CHECKED AT REGULAR
INTERVALS BY COMPETENT PERSONNEL HAVING RECEIVED ADEQUATE TRAINING.
ANY DISASSEMBLY OPERATION SHOULD ONLY BE UNDERTAKEN BY PERSONS
TRAINED IN THE PROCEDURES. DO NOT DISASSEMBLE THE TOOL OR MACHINE
WITHOUT FIRST CONSULTING THE MAINTENANCE INSTRUCTIONS.
• THE TOOL OR MACHINE MUST BE USED AT ALL TIMES IN ACCORDANCE WITH THE
CORRESPONDING HYGIENE AND SAFETY LEGISLATION. ANY QUESTION RELATING TO
THE PROPER USE OF THE TOOL OR MACHINE AND THE SAFETY OF THE OPERATOR
MUST BE ADDRESSED TO DEGOMETAL.
• IT IS UP TO THE CUSTOMER TO EXPLAIN TO EACH OPERATOR THE PRECAUTIONS TO
BE FOLLOWED WHEN USING THE TOOL OR MACHINE.
• ALWAYS DISCONNECT THE AIR HOSE FROM THE TOOL OR MACHINE INLET
CONNECTION BEFORE ANY ADJUSTMENT, ASSEMBLY OR DISASSEMBLY OF A NOSE
ASSEMBLY.
• NEVER DIRECT ANY TOOL OR MACHINE AT ANYONE.
• ALWAYS ADOPT A STABLE POSITION BEFORE USING THE TOOL OR MACHINE.
• MAKE SURE THE AIR HOLES ARE NOT OBSTRUCTED OR MASKED, AND THAT THE
HOSES ARE IN GOOD CONDITION.
In addition to the previous general safety rules, it is necessary to respect the following
specific safety points:
• THE WORKING PRESSURE MUST NOT EXCEED 7 BARS - 100 LBF / IN2.
• DO NOT OPERATE THE TOOL WITHOUT THE NOSE EQUIPMENT, OIL CAP AND DRAIN
SCREW IN PLACE.
• WHEN USING THE TOOL, THE WEAR OF SAFETY GLASSES BY THE OPERATOR AND
BY PEOPLE NEARBY IS MANDATORY, TO PROTECT THEM AGAINST THE EJECTION OF
A NUT WHEN A FIXING IS FITTED. "IN THE AIR". WE RECOMMEND THE WEARING OF
GLOVES IF ANY AREAS OR SHARP ANGLES ARE PRESENT.
• BE CAREFUL TO AVOID LOOSE CLOTHES, TIES, LONG HAIR, CLEANING CLOTH, ETC.
DO NOT COME INTO THE MOBILE PARTS OF THE TOOL. THE TOOL MUST BE KEPT
CLEAN AND DRY TO GIVE THE BEST POSSIBLE GRIP.
• WHEN TRANSPORTING THE TOOL FROM ONE PLACE TO ANOTHER, KEEP YOUR
HANDS AWAY FROM THE TRIGGER OR THE LEVER TO AVOID ANY TRIPPING.
• AVOID PROLONGED SKIN CONTACT WITH HYDRAULIC FLUID. TO MINIMIZE THE RISK
OF IRRITATION, PROCEED WITH A THOROUGH TOILET.
www.degometal.com
18