Safety Instructions - Goulds Pumps Hydro-Pro Serie Directives D'installation, D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Read and Follow

Safety Instructions!

DANGER
WARNING
CAUTION
Safety Instructions
1.
2.
3.
4.
5.
6.
7.
This is the safety-alert symbol. When you see this symbol on your system or in this
manual, look for one of the following signal words and be alert to the potential for
personal injury;
DANGER warns about hazards that will cause serious personal injury, death or
major property damage if ignored.
WARNING warns about hazards that could cause serious personal injury, death or
major property damage if ignored.
CAUTION warns about hazards that may result in minor or moderate injury or
property damage if ignored.
This label NOTICE indicates special instructions which are important but not related
to hazards.
Carefully read and follow all safety instructions in this manual or on system.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
WARNING - THESE WATER TANKS ARE DESIGNED FOR
OPERATION ON AMBIENT TEMPERATURE WATER SYSTEMS LIMITED
TO A MAXIMUM WORKING PRESSURE OF 125 POUNDS PER SQUARE INCH
GAUGE (PSIG). IF YOUR SYSTEM HAS THE ABILITY TO EXCEED 125 PSIG
WORKING PRESSURE (100 PSIG IF THIS IS A PUMP MOUNTED UNIT), A
SUITABLE SAFETY DEVICE MUST BE INSTALLED. THIS CAN BE EITHER A
HIGH PRESSURE ELECTRICAL CUT-OFF SWITCH AND/OR A PRESSURE
RELIEF VALVE. FAILURE TO FOLLOW THESE INSTRUCTIONS CAN CAUSE
TANK RUPTURE AND RESULT IN PERSONAL INJURY AND/OR PROPERTY
DAMAGE.
It is your responsibility to make sure your installation meets all national and
local plumbing and electrical codes.
DANGER
- Before installing or servicing your pump or tank be sure power
source is disconnected.
If a captive air water systems tank replaces a standard galvanized tank on a
submersible pump installation, bleeder orifices or other air charging devices
must be removed. Air charging devices on jet pumps must be removed.
CAUTION - Storage tanks are designed for use on ambient temperature
- (maximum temperature of 120
this product on other applications could cause tank failure and possibly
personal injury. Use of this tank on other applications voids the warranty.
Complete pump, tank and piping system must be protected against freezing.
Failure to do so will cause severe damage and voids the warranty.
DANGER
- Tank contains air pressure. Do not puncture. Never throw tank
into fire or incinerator.
2
o
F, effective Feb. 2001) water systems. Use of

Publicité

Table des Matières
loading

Table des Matières