Télécharger Imprimer la page

Spectra Premium FPW13 Instructions D'installation page 2

Publicité

Les langues disponibles

Les langues disponibles

cautIon
When fuel is involved, work in a well-ventilated area away from sparks and open flames. To eliminate the risk of fire and personal injuries, the fuel lines should
be plugged or capped upon removal. Have a class "B" fire extinguisher nearby. Basic hand tools are necessary to accomplish the repair. Personal safety
equipment should be used when handling flammable materials such as gasoline. Safety glasses, gloves and appropriate clothing (long sleeve shirt, pants and
safety shoes) are necessary to reduce the risk of injuries. Any fuel spill must be handled and cleaned immediately. Consult manufacturer's technical repair
manuals for appropriate procedures.
tHIs Harness Is strIctly Intended For autoMotIVe use
not aPProVed For aIrcraFt or MarIne use
Harness installation procedures
1. Follow repair manual instructions for the fuel
tank removal and pump assembly.
2. Disconnect the fuel pump # 2 wire connector.
3. Disconnect the top flange # 4 wire connector.
4. Disconnect the 2 terminals from the fuel
level sender.
Installing the terminals into
the connector
The wire terminal will only fit the plastic connector
one way.
The locking tab on the terminal (figure A) must
be positioned with the small indent found on the
plastic connector (figure B).
Figure a
Figure B
Plastic connector
Locking tab
indents
Installation instructions
to install a tWo-WIre connector
at the pump top cover
5. Insert the BLACK wire (Larger gauge) into
position opening A. (figure 2.1)
6. Insert the RED wire (Larger gauge) into
position opening B. (figure 2.2)
7. Insert the smaller blue locking tab securing
the terminals into the 2 wire connector.
(figure 2.2)
to install a Four-WIre connector
at the pump top cover
8. Insert the RED and the BLACK wire (Larger
gauge) into position opening E or C.
(figure 4.1) Compare with original harness
that was removed
9. Insert the BLUE and the BLACK wire
(Smaller gauge) into position opening B or D.
(figure 4.2) Compare with original harness
that was removed
10. Insert the large blue locking tab securing the
terminals into the 4 wire connector. (figure 4.3)
Figure 2.1
B
Figure 4.1
w w w . s p e c t r a p r e m i u m . c o m
reconnecting wiring harness
to the fuel pump assembly
11. Install the 4 pin connector to the upper pump
flange assembly.
12. Route the wires along the pump assembly to
prevent wire interference with the float arm.
13. Connect the 2-pin connector to the fuel pump.
14. Connect the fuel level sender wires to the
appropriate terminals on the rheostat.
(figure 2.3)
re-install the fuel pump assembly
into the fuel tank
15. Install fuel pump assembly and tank back into
the vehicle.
FolloW rePaIr Manual InstructIon.
Figure 2.2
A
The locking tab must be inserted
in the back of the connector and
pushed until locked in place
Figure 4.2
Figure 4.3
The locking tab must be inserted between
the wires and pushed until locked in place
BOU-AVM-1-I-38B
Figure 2.3
Fuel level sender (rheostat)
positive and negative
1NW1306

Publicité

loading